###############################################################################
#
# snmpd.conf:
#   An example configuration file for configuring the ucd-snmp snmpd agent.
#
###############################################################################
#
# This file is intended to only be as a starting point.  Many more
# configuration directives exist than are mentioned in this file.  For 
# full details, see the snmpd.conf(5) manual page.
#
# All lines beginning with a '#' are comments and are intended for you
# to read.  All other lines are configuration commands for the agent.

###############################################################################
# Access Control
###############################################################################

# As shipped, the snmpd demon will only respond to queries on the
# system mib group until this file is replaced or modified for
# security purposes.  Examples are shown below about how to increase the
# level of access.

# By far, the most common question I get about the agent is "why won't
# it work?", when really it should be "how do I configure the agent to
# allow me to access it?"
#
# By default, the agent responds to the "public" community for read
# only access, if run out of the box without any configuration file in 
# place.  The following examples show you other ways of configuring
# the agent so that you can change the community names, and give
# yourself write access to the mib tree as well.
#
# For more information, read the FAQ as well as the snmpd.conf(5)
# manual page.

####
# First, map the community name "public" into a "security name"

#       sec.name  source          community
com2sec local     localhost            public
com2sec localNet  10.14.0.0/22      public
com2sec local     default              public

####
# Second, map the security name into a group name:

#       groupName      securityModel securityName
group   rosystem     v1    	local
group   rosystem     v2c        local
group	rogroup      v1		localNet
group	rogroup      v2c	localNet
group	rwgroup      v1		local
group	rwgroup      v2c	local


####
# Third, create a view for us to let the group have rights to:

# Make at least  snmpwalk -v 1 localhost -c public system fast again.
#       name           incl/excl     subtree         mask(optional)
view    all    included   .1 80
view    systemview    included   .1.3.6.1.2.1.25.1.1

####
# Finally, grant the group read-only access to the systemview view.

#       group          context sec.model sec.level prefix read   write  notif
access rogroup  ""      any       noauth    exact     all    none none
access rosystem ""      any       noauth    exact     all    none none
access rwgroup  ""      any       noauth    exact     all    all  none

# -----------------------------------------------------------------------------

# variables through the snmpd.conf file:

syslocation Unknown (edit /etc/snmp/snmpd.conf)
syscontact Root <root@localhost> (configure /etc/snmp/snmp.local.conf)